3. Hardware Installation

Installation

fåëí~ää~íáçå

The figure below illustrates a block diagram of a basic PresentationPRO-II system. This diagram can be used as reference in the following installation procedure.

Program

Projector

Inputs

Analog Sources to Analog Inputs 1-8

SD-SDI Source to SDI Input (SDI Model) SD-SDI/HD-SDI Source to SDI Input (HD Model)

DVI Source to BG/DSK Input

Program Out (Analog)

Program Out (Digital)

Ethernet

(Optional)

To External

Controller

Ethernet Hub / Switch

Figure 3-1.Block Diagram, Basic PresentationPRO-II System

You will need:

Table 3-3.Equipment List, Basic PresentationPRO-II System

Qty.

Item

Note

1

PresentationPRO-II Chassis

 

 

 

 

1

Video Projector and cable

Customer supplied

 

 

 

1

Analog Monitor and cable

Customer supplied

 

 

 

1

Ethernet Hub or Switch

Customer supplied (Optional, with External Controller)

 

 

 

2

Ethernet cables

Customer supplied (Optional, with External Controller)

 

 

 

1

DVI-DVI cable

Customer supplied (for BG/DSK input)

 

 

 

1

Video cable

Customer supplied (for SD-SDI or HD-SDI input)

 

 

 

TBD

Dedicated sources

Analog video as required (customer supplied)

 

 

 

„Use the following steps to install PresentationPRO-II:

1.Follow the unpacking procedures as listed in the “Unpacking and Inspection” section on page 22.

2.As required, refer to the “Physical and Electrical Specifications” section on page 124 in Appendix A for electrical and mechanical details.

3.As required, refer to the PresentationPRO-II Rear Panel” section on page 12 in Chapter 2 for the locations of all connectors.

PresentationPRO-II • User’s Guide

 

25

 

Page 37
Image 37
Barco 26-0405000-00 manual Fåëí~ää~íáçå, You will need