6. Operations
Working with Layers
LOGO |
ildl=qê~åëáíáçåë
With
•Transitioning the LOGO to Program
•Clearing the LOGO from Program
qê~åëáíáçåáåÖ=íÜÉ=ildl=íç=mêçÖê~ã
Using the LOGO source, you can transition a captured still frame to Program at the highest priority layer — covering all effects underneath.
Tip
In addition to its use as a full screen downstream graphic, the LOGO can also be used as a convenient “black preview” function. When the LOGO source is set to Black, you can fade to black at any time, from any simple or complex setup, without affecting the underlying "look."
Use the following steps to transition the LOGO to Program:
1.Ensure that you have preset the desired transition type and rate. Refer to the "Working with Transitions" section on page 115 for details.
2.Ensure that the desired still frames have been captured. Refer to the “Still Frame Capture Overview“ section on page 117 for details.
3.In the Layer Functions Section, press LOGO. The button blinks and the LOGO Input Setup Menu appears.
4.Scroll to the Type line and select FG_1, FG_2, FG_3 or Black.
5.In the Layer Functions Section, press TRANS. The TRANS button lights during the interval, and at the conclusion of the transition, the Home Menu appears.
`äÉ~êáåÖ=íÜÉ=ildl=Ñêçã=mêçÖê~ã
Use the following steps to clear the LOGO from Program:
1.Ensure that you have preset the desired transition type and rate. Refer to the "Working with Transitions" section on page 115 for details.
2.In the Layer Functions Section, press TRANS. The TRANS button lights during the interval, and at the conclusion of the transition, the Home Menu appears. This simple shortcut works because the LOGO is the only layer visible on Program, and thus the only element that can transition off.
Note
If desired, you can also clear the LOGO by pressing LOGO,
CLEAR, TRANS.
|
| 113 |
|
