Barco 26-0405000-00 Click Communication RS232 Config Baud, and select, `K==réÖê~ÇáåÖ=pçÑíï~êÉ

`K==réÖê~ÇáåÖ=pçÑíï~êÉ

Serial Upgrade Method

g.After the download is complete, navigate to the target folder and double- click the EXE to launch the installation shield.

h.Follow the prompts to install the upgrade package in the desired folder. Note that at the conclusion of the procedure, a new path will be created under Start > Programs > Barco Folsom.

Note

Do not move or copy any files out of the target folder.

4.Connect the Serial 1 port on the back of the PresentationPRO-II to the COM 1 port on your PC. In Chapter 2, refer to the “PresentationPRO-II Rear Panel” section on page 12 for the location of the Serial 1 port.

5.Power-up the PresentationPRO-II.

6.On the PC, click Start > Programs > Barco Folsom > PresentationPRO-II Software > PresentationPRO-II Flash Loader to launch the Flash Loader utility, as shown below.

Figure C-1.Flash Loader Utility

Note

If you have not used the COM 1 port on your PC, an error message will be shown at the bottom of the Flash Loader.

7.Click Communication > RS232 Config > Baud, and select 115200.

8.Click Communication > RS232 Config > COM Port, and select the COM port on your PC to which the PresentationPRO-II is connected. If no other programs are using the port, the “Established communications” message appears at the bottom of the Flash Loader.

9.To verify communications between the PC and the PresentationPRO-II unit:

a.In the loader program, click in the black terminal window area.

b.Note the condition of the status lights:

•DCD and CTS should be red.

PresentationPRO-II • User’s Guide 137