6. Operations

Using Remote Control

rëáåÖ=oÉãçíÉ=`çåíêçä

When PresentationPRO-II is controlled from an external controller, the Remote Control Menu is used to set the unit ID and enable/disable remote control itself. Please note the following prerequisites:

Ensure that you know the unit IDs currently in use by the external controller. The external controller will not allow PresentationPRO-II to connect if a duplicate ID is assigned.

If an external router is to be connected to PresentationPRO-II, ensure that the proper physical connections have been made, and that the router is properly configured from the external controller.

„Use the following steps to place PresentationPRO-II under remote control:

1.Press {HOME} > {REMOTE CONTROL} to access the Remote Control Menu.

2.Set the Unit ID to a value that is not used within the external controller’s system.

3.Scroll to the Remote Control line turn it ON.

Important

When remote control is on, the {HOME} buttons disappears, the PresentationPRO-II front panel is disabled, and all control originates from the external controller.

4.In the “Status” section, verify the following:

~Connection status with the external controller.

~Ctrlr IP — the IP address of the external controller.

~Destination — the destination assigned to PresentationPRO-II.

~Router — the utilization of routers, either internal or external.

„Use the following steps to reestablish local PresentationPRO-II control:

1.On the Remote Control Menu, scroll to the Remote Control line turn it OFF. The {HOME} buttons reappears, the PresentationPRO-II front panel is re-enabled, and all control now originates locally.

116

 

PresentationPRO-II • User’s Guide

 

Page 128
Image 128
Barco 26-0405000-00 manual RëáåÖ=oÉãçíÉ=`çåíêçä, Press Home Remote Control to access the Remote Control Menu