Barco 26-0405000-00 manual NWN=páòáåÖ=jÉåì, Input Menu, Menu Orientation

4. Menu Orientation

Input Menu

páòáåÖ=jÉåì

From the Input Menu, press {SIZING} to display one of two Sizing Menus. These menus are context sensitive — they change depending on the Sampling Mode selected on the

Input Menu.

•If 1:1 Sampling is selected, the 1:1 Sizing Menu appears.

•If Oversample is selected, the Oversample Sizing Menu appears. Each menu and function is described below.

NWN=páòáåÖ=jÉåì

The figure below illustrates a sample 1:1 Sizing Menu.

	1:1 SIZING	SRC_3
H	Clock Phase	0
O			N
M			A
E	H Total	[ 858 ]
			V
B	H Active	720
A	H Position	123
C
K
	V Total	[ 0 ]
	V Active	486
	V Position	36
S			A
A			D
V			J
E

Figure 4-7.1:1 Sizing Menu (sample)

•Clock Phase — sets the system’s A/D converter, allowing you to select where pixels are sampled (ideally, on the pixel’s peak). The adjustment range is -16to 15. For optimum visual results when adjusting high-resolution computer sources, project a burst test pattern and adjust the sampling for the minimum noise. Refer to the “Test Pattern Menu” section on page 42 for information.

•H Total — sets the total pixel count per line.

Note

This field is not adjustable for digital sources (including both the DVI and BNC input connectors), or for NTSC and PAL sources, regardless of connection type.

•H Active — sets the width of the active area.

•H Position — sets the start of the active area’s horizontal offset from H sync.

•V Total — fixed value which cannot be adjusted.

•V Active — sets the number of vertical lines in the image.

•V Position — sets the start of the active area’s vertical offset from V sync.

•Press {SAVE} to save the selected input in the designated input file.

PresentationPRO-II • User’s Guide 35