
5. System Setup
Comprehensive Input Setup
Please note:
•When all inputs have been acquired and saved, the Input Acquisition Menu will only
•If you need to fine tune your inputs (or if you change inputs), the Input Menu can be accessed at any time by pressing {HOME} > {INPUT}.
Please continue with the “Comprehensive Input Setup” section on page 90.
`çãéêÉÜÉåëáîÉ=fåéìí=pÉíìé
This procedure enables you to perform a more comprehensive input setup, if required.
Note
If your initial input acquisition was successful (as performed in the “Quick Input Setup Procedure” section on page 89), there is generally no need to perform all steps in the “comprehensive” setup. Typically, you may wish to adjust input “sizing” to properly fit each input within the PIP’s boundaries — so that no black edges are visible.
Please note the following important input setup prerequisites:
•Ensure that you are familiar with the Input Menu and all sub menus included on that screen. In Chapter 4, refer to the “Input Menu Functions” section on page 30 for complete details.
•Ensure that you have completed your input connection chart. In Chapter 3, refer to the “Input Connection Chart” section on page 24 for details and instructions.
Use the following steps to set up inputs:
1.In the Layer Functions Section, press PIP.
2.On the Source Selection Bus, select the input that you want to set up. The button will blink.
3.From the Home Menu, press {INPUT} to access the Input Menu.
a.On the menu’s top row, ensure that the selected input is correct (e.g., SRC_1 or SRC_4).
b.If required, press {FORCE ACQUIRE} to force the system to perform the optimum setup on the selected input. If the operation is successful, the Format, Input Type and Color Space fields should correctly reflect the characteristics of the incoming signal.
c.If required, scroll to the Format line and manually set the resolution of the incoming source. In Appendix A, refer to the “Input and Output Resolutions“ section on page 129 for details on all available resolutions.
d.If you manually selected a format in the previous step, press {SELECT FORMAT} to “accept” and activate the selection.
e.If required, scroll to the Input Type line and set the type of input connected to the chassis. Remember that available choices change depending on the selected Format.
90 |
|
|
|