Cycle Power To a System For the First Time
Adapter Features
When you power POINT I/O for the first time, the adapter must assign addresses to every module in the backplane. POINT I/O modules all ship configured at the same address.
When you first apply power, we expect that all but one module on the backplane exhibits a solid red Module Status LED.
One by one the adapter resets these modules and addresses them appropriately. The amount of time that this operation takes is proportional to the size of your POINT I/O system.
The
•EtherNet/IP messages encapsulated within standard TCP/UDP/IP protocol
•Common application layer with ControlNet and DeviceNet networks
•Interfacing via Category 5 rated twisted pair cable
•Half/full duplex 10 Mbit or 100 Mbit operation
•DIN rail mounting
•Communication to and from other POINT I/O modules on the same DIN rail
•Communication supported by RSLinx software
•IP address assigned via standard BootP or DHCP tools
•I/O configuration via RSLogix 5000 software
•No network scheduling required
•No routing tables required
•Support of connections from multiple controllers simultaneously
Publication
