Bradley Smoker 1734-AENT manual Add the Point I/O Module and Configure For Rack Optimization

Chapter 5

Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software

What This Chapter Contains This chapter guides you through the steps required to configure your 1734 POINT I/O Ethernet adapter for both direct connection and rack

optimization using RSLogix 5000 software.

You can mix communication formats for different I/O modules communicating through the same adapter. I/O modules set up to use rack optimization communicate at the rate of the RPI configured for the 1734-AENT adapter.

I/O modules configured for direct communication communicate at their own set RPI and ignore the 1734-AENT adapter RPI. The modules presented in this chapter have a configuration using RSLogix 5000 software, version 15. The chapter contains the following main sections:

What You Do	See Page
Set Up the Hardware	5-2
Create the Example Application	5-3
Configure the I/O Modules	5-4
Add the Local EtherNet/IP Bridge to the I/O Configuration	5-4
Add the POINT I/O Adapter to the I/O Configuration	5-7
Add the POINT I/O Module and Configure for Direction	5-11
Connection
Add the POINT I/O Module and Configure For Rack Optimization	5-14
Download the Program to the Controller	5-17
Verify the Module Chassis Size	5-18
Access Module Data	5-21

ATTENTION

You must use series C POINT I/O modules with the 1734-AENT adapter. Series A or B POINT I/O modules will not work with this adapter.

Publication 1734-UM011C-EN-P - January 2006