Mount the Adapter on a DIN Rail Before Installing Modules
Use the following procedure to mount the adapter on a new system before you install any I/O modules.
43520
1.Position the adapter vertically above the DIN rail.
2.Press down firmly to install the adapter on the DIN rail, noting that the locking mechanism locks the adapter to the DIN rail.
3.Set the network address thumbwheel switches to the desired value (see Set the Network Address section in this manual).
WARNING
If you connect or disconnect the Ethernet cable with power applied to this module or any device on the network, an electrical arc can occur. This could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
4.Slide the safety end cap up to remove it.
This exposes the backplane and power interconnections.
ATTENTION
Do not discard the adapter’s end cap. Use this end cap to cover the exposed interconnections on the last mounting base on the DIN rail. Failure to do so could result in equipment damage or injury from electric shock.
Publication
