Adapter Web Pages | |
|
|
1.From the Home page, click Configuration or Expand to see the Configuration options, if needed.
2.From the Configuration page, click one of these.
•Identity
•Network
•Services
You see a dialog prompting you for a user name and password, as shown in the figure that shows a typical example, noting that your dialog may look different, depending on your operating system and browser.
3.From the user name and password dialog, enter values, noting the following.
•The values for user name and password are case sensitive.
•The default user name is admin.
•The default password is password.
4.From the user name and password dialog, click OK to log in, noting that after you log in you can go to any of the Configuration pages without logging in again.
5.Refer to the section of this manual that describes which of these you clicked: Identity, Network, Services.
Use the Identity Page
To use the Identify page to make entries for the host name, module description, module location, and chassis size, use this procedure.
1.From the Web page, click Identity from the tab at the top of the page or panel on the left.
