
Chapter 3
Configure the Adapter for Your EtherNet/IP
Network
What This Chapter Contains Before using your adapter in an EtherNet/IP network, configure it with an IP address, subnet mask, and optional Gateway address. This
chapter describes these configuration requirements and the procedures for providing them. Here are ways you can do this:
•Use the Rockwell BootP utility, version 2.3 or later, that ships with RSLogix 5000 or RSLinx software.
–You can also use this utility to reconfigure a device with an IP address you must change.
•Use a third party DHCP server.
•Use the Network Address thumbwheel switch.
•Have your network administrator configure the adapter via the network server.
See the table for a list of where to find information in this chapter.
For Information About | See Page |
|
Configuration Requirements |
| |
|
|
|
IP Address |
| |
|
|
|
Gateway Address |
| |
|
|
|
Subnet Mask |
| |
|
|
|
Set the Network Address |
| |
|
|
|
Use the Rockwell BootP/DHCP Utility |
| |
|
|
|
Save the Relation List |
| |
|
|
|
Use DHCP Software to Configure Your Adapter |
| |
|
|
|
|
|
|
ATTENTION
You must use series C POINT I/O modules with the
Publication