Configuration Requirements
Before you can use your adapter, you must configure its IP address, its subnet mask, and, optionally, gateway address. You can use the Rockwell BootP utility, version 2.3 or later, to perform the configuration. You can also use a DHCP server or the network address switches to configure these parameters.
If you need to reset the adapter to factory defaults, see the Important note about setting thumbwheels to the value 888.
IP Address
Ethernet Address (MAC)
IMPORTANT
If you set the thumbwheels on the adapter to the value 888 and then power cycle the module, the following will occur.
•The DHCP Enabled function is enabled (set to True).
•The Ethernet link is negotiated automatically (the Auto Negotiate function will be set to True).
•The web server is enabled (the Disabled Web Server function is disabled).
•The password for this page resets to the factory default (the word password is the factory default password).
Note the value of the switches before you enter the 888 value, because you return the adapter to those values once this process is complete.
Publication
