Carrier 30XW150-400 specifications 113

APPENDIX B — NAVIGATOR™ DISPLAY TABLES (cont)

MODE — CONFIGURATION (cont)

ITEM	EXPANSION	UNITS	RANGE	COMMENT	DEFAULT	CCN TABLE	CCN POINT	PAGE NO.
OPTN	OPTIONS CONFIGURATION
→ CCNA	CCN Address	XXX	1-239		1	N/A	CCNA
→ CCNB	CCN Bus Number	XXX	0-239		0	N/A	CCNB
→ BAUD	CCN Baud Rate		2400		9600	N/A	BAUD
			4800
			9600
			19200
→ LOAD			38400
	Loading Sequence Select		Equal		EQUAL	USER	lead_cir	29
→ LLCS			Staged
	Lead/Lag Circuit Select		Automatic		AUTOMATIC	USER	seq_typ	29, 55
			Cir A Leads
			Cir B Leads
→ RL.S			Cir C Leads
	Ramp Load Select		ENBL/DSBL		DSBL	USER	ramp_sel	35
→ DELY	Minutes Off Time	XX (Minutes)	1 to 15		1	USER	off_on_d	29
→ ICE.M	Ice Mode Enable		ENBL/DSBL		DSBL	USER	ice_cnfg	41
→ HPUM	Condenser Pumps Sequence	X	No Pump	Not supported.	NO PUMP		hpum_seq	47
			1 Pump Only
			2 Pumps Auto
			PMP 1 Manual
→ PUMP			PMP 2 Manual		NO PUMP	USER	pump_seq	28, 47
	Cooler Pumps Sequence		No Pump
			1 Pump Only
			2 Pumps Auto
			PMP 1 Manual
→ ROT.P			PMP 2 Manual
	Pump Rotation Delay	XXXX (hours)	24 to 3000	Not supported.	48	USER	pump_del	28, 55
→ PM.PS	Periodic Pump Start		NO-YES	Not supported.	NO	USER	pump_per	28, 55
→ P.SBY	Stop Pump In Standby		NO-YES	Not supported.	NO	USER	pump_sby
→ P.LOC	Flow Checked if Pmp Off		NO-YES	Not supported.	YES	USER	pump_loc	28
→ LS.ST	Night Low Noise Start	XX.XX	00.00-23.59		00.00	USER	nh_start
→ LS.ND	Night Low Noise End	XX.XX	00-00-23.59		00.00	USER	nh_end
→ LS.LT	Low Noise Capacity Lim	XXX (%)	0-100		100	USER	nh_limit	55
→ RV.AL	Reverse Alarms Relay		NO-YES		NO	USER	al_rever
→ OA.TH	Heat Mode OAT Threshold	XX.X		Not supported.	5 F	USER	heat_th
→ FREE		(deg F/deg C)
	Free Cooling OAT Limit	XX.X		Not supported.	32.0	USER	free_oat
→ CUR.S	Current Limit Select	(deg F/deg C)	NO/YES		NO		curr_sel	39-41
→ CUR.F	Current Limit at 100%	XXXX	0 to 5000		2000		curr_ful	40-41
RSET	RESET, DEMAND LIMIT, MASTER/SLAVE
→ CRST	Cooling Reset Type		No Reset		NO RESET	USER	cr_sel	33, 36, 55
			Out Air Temp
			Delta T Temp
			4-20 mA Input
→ HRST			Space Temp
	Heating Reset Type		No Reset	Not supported.	NO RESET	USER	hr_sel
			Out Air Temp
			Delta T Temp
→ DMDC			4-20 mA Input
	Demand Limit Select		None		NONE	USER	lim_sel	39-41, 55
			Switch
→ DMMX	mA for 100% Demand Limit	XX.X (mA)	4-20 mA Input		0.0	USER	lim_mx	40, 41
→ DMZE	mA for 0% Demand Limit	XX.X (mA)			0.0	USER	lim_ze	40, 41
→ MSSL	Master/Slave Select		Disable		DISABLE	MST_SLV	ms_sel	32-35, 55
			Master
→ SLVA			Slave
	Slave Address	XXX	1-236		2	MST_SLV	slv_addr	29, 32-35
→ LLBL	Lead/Lag Balance Select		Always Lead		Always	MST_SLV	ll_bal	29, 32-35,
			Lag if Fail		Lead			54
→ LLBD			Runtime Sel
	Lead/Lag Balance Delta	XXX (hours)	40-400		168	MST_SLV	ll_bal_d	29, 32-35
→ LLDY	Lead/Lag Delay	XX (minutes)	2-30		10	MST_SLV	lsrt_tim	30, 32-35,
→ LL.ER								54
	Start if Error Higher	XX.X	3-18		4	MST_SLV	start_dt	30, 32-35
→ LAG.M		(deg F/deg C)
	Lag Minimum Running Time	XXX	0-150		0	MST_SLV	lag_mini	30, 32-35
→ LAGP	Lag Unit Pump Select	(min)	OFF if U stp		OFF if U stp	MST_SLV	lag_pump	30, 32-35,
→ LPUL			ON if U stp					54
	Lead Pulldown Time	XX (minutes)	0-60		0	MST_SLV	lead_pul	30, 32-35,
→ SERI								54
	Chillers in Series		NO/YES				ll_serie	29, 32-35

113