Carrier 30XW150-400 Setup Menu Button Function, Regional, Language, Contrast, Backlight, Display

a30-4474

Fig. 6 — Setup Menu Display

	Table 1 — Setup Menu
SETUP MENU BUTTON	FUNCTION
	This button specifies the time and date format and the base unit of measure. Time display can be configured as
REGIONAL	12-hour AM/PM setting or as a 24-hour setting. The date can be formatted in one of 3 settings, MM-DD-YYYY (Month-
	Day-Year), DD-MM-YYYY (Day-Month-Year), or YYYY-MM-DD (Year-Month-Day). Units of measure can be either US
	(English) or Metric (SI).
LANGUAGE	This button selects the active language and font of the display. Available languages are English and Spanish (Espanol).
	If a preferred language is not available, additional software for the Main Base Board (MBB) and the Touch Pilot™ dis-
	play are required. Contact your Carrier representative for instructions and software.
	This button adjusts the LCD contrast. Press and hold the [MOON] button to increase/darken the contrast or the [STAR]
CONTRAST	button to decrease/lighten the current contrast.
	NOTE: Touching the screen anywhere for 5 seconds while powering-up will prompt the user to restore contrast and
	calibration settings to factory defaults.
BACKLIGHT	This button specifies whether backlighting should be kept on at all times or turned off during inactive periods.
CALIBRATE	This button is used to adjust the LCD touch screen calibration. Touch the screen in the circular targets located first in
	the upper left and then in the lower right corner of the screen to adjust.
	This button is used to configure the limited and full logged-in access system passwords. In order to change passwords,
	the user must be logged in with full access to view and change the passwords. All passwords must consist of 4-digits,
	which can be entered using the numeric keypad. Access levels and associated privileges are as follows:
	Limited Logged-in Access - Provides the user with read/write access to all available tables (except service configura-
	tion tables, where the user will not be permitted to modify point data, and Group Display tables, where the user will not
PASSWORDS	be permitted to add points.) This access level also provides read/write access to all Touch Pilot display setup properties
	except Display, CCN, and Password.
	Full Logged-in Access - Provides user with read/write access to all available tables for the attached device and all
	Touch Pilot display properties.
	If the user does not log in, read-only access to all tables is allowed. The user will be prompted to log in when attempting
	to access password-required functions.
	This button is used to view the description data and part number from the Ctlr-ID Table and to specify the Operating
	Mode. The Operating mode can be configured for Equipment mode or Network mode. For Touch Pilot displays that are
	standard with the unit, Operating mode should not be changed from Equipment mode. Equipment mode provides
	access only to the chiller’s MBB via the Local Equipment Network (LEN) Bus. For remote access, a remote Touch Pilot
DISPLAY	display can be set to Network mode. Network mode provides access to all devices on the CCN (Carrier Comfort Net-
	work®) bus.
	NOTE: When changing the operating mode, a power cycle is required in order for the new operating mode to take
	effect. The user should view and correct the following CCN data: address and baud rate, alarm acknowledger, and
	broadcast acknowledger designation.
CCN	This button is used to configure the bus and element numbers and the baud rate of the control on the network.

6