Dot Hill Systems II 200 FC service manual # kermit, C-Kermitset line /dev/tty0p1

COM port

COM port

Figure H-1RAID Array COM Port Connected Locally to the Serial Port of a Host System

2.Power on the array.

3.After the array is powered up, power on the IBM server and log in as root, or become superuser if you are currently logged in as a user.

4.Start the Kermit program and set the parameters as shown.

Use the device-specific name for the serial port you are using. In the example, the serial port being configured is /dev/tty0p1.

#kermit

Executing /usr/share/lib/kermit/ckermit.ini for UNIX...

Good Morning!

C-Kermit 7.0.197, 8 Feb 2000, for HP-UX 11.00 Copyright (C) 1985, 2000,

Trustees of Columbia University in the City of New York. Type ? or HELP for help.

(/)C-Kermit>set line /dev/tty0p1

(/)C-Kermit>set baud 38400 /dev/tty0p1, 38400 bps

(/)C-Kermit>set term byte 8

(/)C-Kermit>set carrier-watch off

(/)C-Kermit>C

Connecting to /dev/tty0p1, speed 38400.

The escape character is Ctrl-\ (ASCII 28, FS)

Type the escape character followed by C to get back, or followed by ? to see other options.

----------------------------------------------------

Note – To return to the Kermit prompt type Ctrl \ and then C. To exit Kermit, first return to the Kermit prompt and then type exit.

Appendix H Configuring an IBM Server Running the AIX Operating System H-3