Dot Hill Systems II 200 FC service manual Host port FC0 Host port FC1 Host port FC4

No SFPs are plugged into the drive channels. This configuration is appropriate for connecting to up to four hosts or fibre switches, with no connection to expansion units (see Figure 4-19and Figure 4-20).

Host port FC0 Host port FC1 Host port FC4 Host port FC5

Figure 4-19SANnet II 200 FC Array Default Single Controller SFP Placement

H/D/RCC

		Host port FC4
Host port FC0	Host port FC1	Host port FC5

Figure 4-20SANnet II 200 SATA Array Default Single-Controller SFP Placement

Note – The SANnet II 200 SATA SE array configuration does not include SFPs. SFPs must be ordered separately.

In a default SANnet II 200 FC expansion unit, SFPs are initially plugged into the left- most port of the upper I/O expansion module and right-most port of the lower I/O expansion module (see Figure 4-21).

Note – The SANnet II 200 SATA SE array does not support this configuration.

Chapter 4 Connecting Your Array 4-23