Dot Hill Systems II 200 FC service manual Safety Precautions

The customer is responsible for meeting all government codes and regulations concerning facilities. The customer is also responsible for compliance with the following requirements:

■Meeting all local, national, and international codes covered in Appendix A. The subjects covered include fire and safety, building, and electrical codes.

■Documenting and informing Dot Hill, Inc. of any deviations from Appendix A.

2.2Safety Precautions

For your protection, observe the following safety precautions when setting up your equipment:

■Follow all safety precautions and requirements specified in the SANnet II Family Safety, Regulatory, and Compliance Manual.

■A fully loaded array weighs over 59 pounds (27 kilograms). To avoid injury, use two people to lift the array.

■Follow all cautions and instructions marked on the equipment.

■Ensure that the voltage and frequency of your power source match the voltage and frequency inscribed on the equipment’s electrical rating label.

■Never push objects of any kind through openings in the equipment. Dangerous voltages might be present. Conductive foreign objects could produce a short circuit that could cause fire, electric shock, or damage to your equipment.

■Dot Hill products are designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electric shock, do not plug Dot Hill products into any other type of power system. Contact your facilities manager or a qualified electrician if you are not sure what type of power is supplied to your building.

■Your Dot Hill product is shipped with a grounding-type (three-wire) power cord. To reduce the risk of electric shock, always plug the cord into a grounded power outlet.

■Do not use household extension cords with your Dot Hill product. Not all power cords have the same current ratings. Household extension cords do not have overload protection and are not meant for use with computer systems.

■Do not block or cover the openings of your Dot Hill product. Never place a Dot Hill product near a radiator or heat register. Failure to follow these guidelines can cause overheating and affect the reliability of your Dot Hill product.

2-2SANnet II 200 FC, SATA, and SATA SE Array Installation, Operation, and Service Manual • March 2005