Dot Hill Systems II 200 FC RJ-45 Connector DB9 COM Port, Setting Up the Serial Port Connection

8.5	Recovering From Fatal Drive Failure		. 8–8
8.6	Using the Reset Push Button		8–10
8.7	Troubleshooting Flowcharts		8–11
	8.7.1 Power Supply and Fan Module		8–11
	8.7.2	Drive LEDs	8–13
	8.7.3	Front-Panel LEDs	8–16
	8.7.4	I/O Controller Module	8–21
A. SANnet II 200 FC, SATA, and SATA SE Array Specifications			A–1
A.1	Physical Specifications		A–1
A.2	SANnet II 200 FC, SATA, and SATA SE Array Highlights		A–2
A.3	Agency Approvals and Standards		A–4
B. Using a Standalone JBOD Array (SANnet II 200 FC Array Only)			B–1
B.1	Supported Configurations (JBOD Arrays)		B–1
B.2	Supported Operating Systems (JBOD Arrays)		B–2
B.3	Supported Host Platforms and Connection Methods (JBOD Arrays)		B–2
B.4	Known Limitations Affecting SANnet II 200 FC JBOD Arrays		B–2
B.5	Using SANnet II Family Software Monitoring and Management Tools with
	JBOD Arrays		.B–3
B.6	Setting the Loop ID on a SANnet II 200 FC JBOD Array		B–4
B.7	Connecting SANnet II 200 FC JBOD Arrays		B–6
B.8	Enabling SANnet II 200 FC JBOD Array Support		B–10
B.9	Downloading Firmware to Disk Drives in a JBOD		B–11
B.10	Resizing LUNs Greater Than 1 Tbyte		B–12
B.11	Troubleshooting SANnet II 200 FC JBOD Arrays		B–12
B.12	Converting a JBOD to a RAID array		B–16
C. Failed Component Alarm Codes			C–1
D. Cable Pinouts		. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .	D–1
D.1	RJ-45 Connector		D–1
D.2	DB9 COM Port		D–2
E. Configuring a Sun Server Running the Solaris Operating System			.E–1
E.1	Setting Up the Serial Port Connection		E–1

Contents vii