Functions & Installation 1. Safety
1.3EMERGENCY STOP
WARNING
Immediately press the EMERGENCY STOP switch whenever you suspect any danger. The Teach Pendant is equipped with an EMERGENCY STOP switch. Before operating the Teach Pendant, make sure that the EMERGENCY STOP switch on the Teach Pendant functions properly. Operating the Teach Pendant when the switch does not function properly is extremely hazardous and may result in serious bodily injury and/or serious damage to the equipment, as the switch cannot fulfill its intended function in an emergency.
When nothing appears on its display window, the Teach Pendant is not connected with the Controller. In this case, the EMERGENCY STOP switch on the Teach Pendant will not function.
When the EMERGENCY STOP switch is pushed, stops the programs execution and halts the robot excitation. Programs and point data will not be damaged.
When pushed, the EMERGENCY STOP switch mechanically holds that state and electrically holds the emergency stop state.
Reset EMERGENCY STOP
Follow these steps to reset Emergency Stop condition.
(1)Remove the cause of the Emergency Stop and verify that it is safe to operate the robot again.
(2)Release the EMERGENCY STOP switch. To release the mechanical latch, turn the EMERGENCY STOP switch to the right.
(3)Turn the Teach Pendant mode selector key switch to “Teach”.
(4) Press the <Reset> key on the operation | |
panel to reset the Emergency Stop. |
|
(5)Make sure that the
<Reset> Key
TP1 Rev.5 | 7 |
