I/O Setup and System Configuration

Step

Screen

 

 

3CAT CONTROL

CAT1

CAT2

CAT3

DIAGNOSTICS

PREV NEXT

4CAT CONTROL OUTPUT 1 SCALING LINFIXEDRNG

INPUTC1

SETPOINT

12000μS

PB LIMIT

300μS

 

 

 

DIAGNOSTICS

 

 

PREV

NEXT

 

5RETRANSMISSION OUTPUT 1

OUTPUT 2

DIAGNOSTICS

PREV NEXT

6OUTPUT 1

SCALING LINFIXEDRNG

 

INPUT

C1

 

 

0%

0.0µS

 

 

100%

19.0µS

 

 

 

 

 

 

DIAGNOSTICS

 

 

 

PREV

NEXT

 

 

 

 

 

Action

Select an output to configure it for control.

Go to the next screen.

The input type and appropriate unit of measure will already be filled in, based on the process variable or computed value assigned to this analog output during I/O setup. The scaling characteristic will also be filled in; CAT output is always linear fixed-range. (All this is read-only information.)

Use the setpoint and proportional band parameters to define the output span.

To configure retransmission on a unit with a single analog output, go to CONFIGURATION

CAT/RETRANSMISSION RETRANSMISSION.

To configure retransmission on a unit with three analog outputs go to CONFIGURATION CAT/RETRANSMISSION and select the output to be configured.

For each output to which a process variable or computed value was assigned during I/O setup, the value assigned will be displayed, as well as the type of scaling to be applied, and the appropriate unit of measure. (This is read-only information.)

Specify the range by entering the values to be represented by outputs of 0% and 100%. If reverse-acting output is required, enter the high range value at the 0% prompt and the low range value at the 100% prompt.

7/99

9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual

5-11

Page 67
Image 67
Honeywell 9782 Series manual CAT/RETRANSMISSION Retransmission