Introduction

1.4 Menu Hierarchy

Menus for every task

For your convenience, menus are provided for configuration, calibration, maintenance, and I/O setup tasks. The menu hierarchy is shown in Table 1-2. Not every menu item applies to every system.

Table 1-2 9782 Conductivity/Resistivity Analyzer/Controller Menu Hierarchy

Menu Item

CONFIGURATION

CAT/RETRANSMISSION

ALARMS

DISCRETE CONTROL

ADVANCED FEATURES

Purpose

set up Analyzer/Controller to implement your alarm and control strategy

configure parameters for using analog outputs for control and retransmission of process values

specify value to be alarmed, alarm setpoints, deadbands, and delay

specify setpoints, range limits, etc. to use relays for control

set the clock, set up automatic cell cleaning, and specify the computed value to be displayed

Where

Described

Section 5

5.4

5.6

5.5

5.7, 5.8, 5.9

CALIBRATION

CELL CAL FACTOR

CALIBRATION TRIM

TDS CONVERSION FACTOR C1 TDS CONVERSION FACTOR C2

calibration functions

enter cell-specific cal factor

calibrate system using a reference solution with each cell; remove trim

enter a process-specific total dissolved solids conversion factor for each cell

Section 8

8.3

8.4, 8.5

8.6

Table 1-2 continued on next page

7/99

9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual

1-11

Page 25
Image 25
Honeywell 9782 Series manual Menu Hierarchy, Configuration, Calibration