
4. POWER WIRING | ||
4.1 | Overview | |
| Introduction | |
| What’s in this section? | |
4.2 | General Wiring Practices for Power Wiring | |
| Safety precautions | |
| Avoid damage to components | |
| Wiring for immunity compliance | |
| Conform to code | |
4.3 | Power Wiring Considerations | |
| Recommended wire size | |
| Power supply voltage and frequency within specs | |
4.4 | Installing Power Wiring | |
| Procedure |
5. I/O SETUP AND SYSTEM CONFIGURATION | |
5.1 Overview | |
Introduction | |
What’s in this section? | |
Powering up the Analyzer/Controller | |
5.2 I/O Setup and Configuration Tasks | |
Ease of configuration | |
Accessing the I/O setup and configuration menus | |
Purpose of I/O setup | |
Purpose of configuration menu items | |
Illustrations | |
System defaults | |
5.3 Performing I/O Setup | |
Purpose | |
Display resolution and unit of measure |
5.4 Configuring Current Adjusting Type (CAT) Control and/or Retransmission of Process
| Purpose | |
| Procedure | |
5.5 | Configuring On/Off, Duration Adjusting Type (DAT), or Pulse Frequency Type (PFT) | |
| Purpose | |
| Procedure | |
5.6 | Configuring Alarms | |
| Purpose | |
| Procedure | |
5.7 | Setting the Clock | |
| Purpose | |
| Procedure | |
5.8 | Configuring AutoClean | |
| Purpose | |
| ||
| ||
| Hold mode |
vi | 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual | 6/99 |