Honeywell 9782 Series manual Calibration

8. CALIBRATION		8-1
8.1	Overview	8-1
	Introduction	8-1
	What’s in this section?	8-1
	Calibration menu customized for different configurations	8-1
8.2	Recommendations for Successful Measurement and Calibration	8-3
	Selection and care of cell essential	8-3
	Recommendations	8-3
8.3	Entering the Cal Factor for Each Cell	8-4
	Introduction	8-4
	Procedure	8-4
8.4	Performing Calibration Trim	8-5
	Introduction	8-5
8.5	Removing Calibration Trim Values	8-7
	Introduction	8-7
	Procedure	8-7
8.6	Determining and Entering the TDS Conversion Factor	8-8
	Introduction	8-8
	Determining TDS conversion factor	8-8
	Out-of range-values forced to closest limit	8-8
	Calibrate the Analyzer/Controller before entering TDS conversion factor	8-8
	Procedure	8-9

9. DIAGNOSTICS AND MESSAGES		9-1
9.1	Overview	9-1
	Introduction	9-1
	What’s in this section?	9-1
9.2	System Status Messages	9-2
	Related to operation of Analyzer/Controller	9-2
9.3	Process Alarm Messages	9-3
	Alarms dependent on configuration	9-3
9.4	On-Line Diagnostics and System Error Messages	9-4
	Self-tests at 0.5 second intervals	9-4
	Output affected by error	9-4
9.5	Off-Line Diagnostics	9-5
	Introduction	9-5
	9.5.1 Display and Keyboard Test	9-5
	Procedure	9-5
	9.5.2 Output Tests	9-7
	Procedure	9-7

viii 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual 6/99