
5.9 Selecting a Computed Value to Be Displayed | |
Purpose | |
Procedure | |
5.10 Summary of Menu Choices and System Defaults | |
Introduction |
6. INPUT AND OUTPUT WIRING | |
6.1 Overview | |
Introduction | |
What’s in this section? | |
6.2 General Wiring Practices for I/O Wiring | |
Safety precaution | |
Avoid damage to components | |
Immunity Compliance | |
Conform to code | |
Recommended maximum wire size | |
Cables for locations without interference | |
Shielded wiring for locations with interference | |
Avoiding interference | |
References | |
6.3 Wiring Analog Inputs and Outputs | |
Introduction | |
Cell identification significant to computed value | |
Procedure | |
6.4 Wiring Relays | |
6.4.1 Installation | |
Introduction | |
Procedure | |
6.4.2 Disconnecting RC Arc Suppression Circuits | |
Introduction | |
Procedure | |
6.4.3 Wiring a Device to the Relay Indicating Output Range Status | |
Introduction | |
Interconnections |
7. AUTOCLEAN THEORY AND PIPING | ||
7.1 | Overview | |
| Introduction | |
| What’s in this section? | |
7.2 | AutoClean Sequence and Piping | |
| Rinse sequence | |
| Select valves and fittings with appropriate pressure ratings | |
| Minimize liquid volume in system |
6/99 | 9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual | vii |