Conductivity/Resistivity Analyzer/Controller
9.2 System Status Messages
Related to operation of Analyzer/Controller
System status messages, displayed on the alarm stripe, are related to normal operation of the Analyzer/Controller. These messages are listed in Table
Table 9-1 System Status Message
MESSAGE
WHEN DISPLAYED
AUTO CLEAN
CAL ADJ FAILED
RETRIEVING DATA
This message is displayed temporarily and indicates that an AutoClean operation is active. All alarms and outputs are held for the duration of the AutoClean operation.
To see how much time is remaining until the next scheduled AutoClean operation, use the DISPLAY key to access the special Time Remaining screen.
This message indicates that a calibration operation has been unsuccessful.
This message is displayed during I/O setup, configuration, and calibration while the unit retrieves data from its memory.
ENTERING DATA
This message is displayed during I/O setup, configuration, and calibration while the unit processes data entered by the user.
INPUT RANGE TOO HIGH INPUT RANGE TOO LOW
User input was either greater than or less than the allowable range.
9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual | 7/99 |
