Conductivity/Resistivity Analyzer/Controller

10.6 Entering a Password for Security

Introduction

I/O setup, configuration, calibration and maintenance functions can be password-protected. The password can be any number between 1 and 9999. (When the password is zero, the operator will not be prompted to enter a password.)

ATTENTION

The configurable password entered here is not the same as the special password needed to edit the model number stored in memory as described in 10.5.

Procedure

Follow the procedure in Table 10-5 to enter a password.

Step

Table 10-5 Procedure for Entering a Password

Screen

Action

 

 

1

2

MENU

CONFIGURATION

CALIBRATION

MAINTENANCE

I/O SETUP

DIAGNOSTICS

PREV NEXT

MAINTENANCE OFFLINE FUNCTIONS

INSTRUMENT SETUP

LEAD RESISTANCE COMP

DIAGNOSTICS

PREV NEXT

INSTRUMENT SETUP INSTURMENT TAGGING PRODUCT INFO SCREEN CONTRAST

SECURITY

RESET UNIT

DIAGNOSTICS

PASSWORD SECURITY

ENABLE SECURITY: YES

PASSWORD: 0000

DIAGNOSTICS

Go to MAINTENANCE INSTRUMENT SETUP

SECURITY.

To enable the security function, select YES.

The current password will be displayed. It can be edited using this screen.

10-10

9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual

7/99

Page 126
Image 126
Honeywell 9782 Series manual Entering a Password for Security, Step Procedure for Entering a Password Screen Action