
Setting Up the Analyzer
To Switch the Analyzer On and Off
To Switch the Analyzer On and Off
After you connect the analyzer to the computer, you can switch on the equipment.
2 Turn on the power switch.
1 | Turn on the computer power switch. |
|
|
| |||
| The analyzer takes approximately two minutes to run its | ||
| switch on. While it is switching on, the Power LED flashes green, and if the | ||
| analyzer is booting from a PC or LAN, the Access LED flashes orange. | ||
| When the analyzer is on, the Power LED remains green and the Access | ||
| LED flashes orange intermittently. If the Power LED stays red, contact | ||
| your HP support representative. | ||
| To switch off the analyzer, switch off the power to the computer and the | ||
| analyzer. When you switch off, the analyzer performs a shutdown under | ||
| software control which makes sure all files are properly closed. | ||
| When you switch off the analyzer, the Power LED flashes green during | ||
| shutdown and then goes off. | ||
Caution | Make sure shutdown is complete before unplugging or removing the | ||
| power cables, or switching off power at the AC wall outlet. |