
Setting Up the Analyzer
To Insert or Remove an Interface Pod
| To Insert or Remove an Interface Pod |
| Interface pods can be inserted or removed from the analyzer at any time. |
| The power does not need to be switched off. You insert an interface pod |
| when you initially set up the analyzer, and subsequently when you change |
| the type of line to be monitored. |
Caution | Handle the interface pod with extreme care to avoid electrostatic |
| discharge (ESD) damage during unpacking, installation, and operation. |
| The connectors on the front and back of the interface pod are susceptible |
| to ESD. |
| The analyzer uses high speed digital interfaces which are susceptible to |
| ESD. ESD may cause received data to be corrupted. |
To Insert an Interface Pod into the Analyzer
1Hold the interface pod with the
2Insert the interface pod into Port 1 or Port 2 of the analyzer.
3Push the interface pod firmly into the analyzer until the connectors are properly seated. The clip on the base of the interface pod clicks into place when the interface pod is fully inserted.
The analyzer automatically sets the transmit and receive parameters according to the signal it receives from the interface pod. The port is automatically configured for full duplex mode.