
Using the Analyzer
To Connect to the System Under Test
Port 1 | Port 2 |
Tx
Rx
Equipment under test
The network element connection is an
∙protocol transfer and conversion
∙connection verification
∙quality of service parameters
∙policing mechanisms
Configure the affected port(s) for full duplex for the network element connection. If you use the receive loopback configuration or the recovered clock timing source, make sure the network element transmitter is synchronized to an independent timing reference (to avoid problems that may be caused by possible clock failure).
Remote Loopback Test Connection
The remote loopback test connection is an
Port 1
Tx |
| Tx |