IBM SA38-0512-03 manual 327043 43P Series Service Guide

Repeat this step until the defective FRU is identified or all the FRUs have been exchanged.

If the symptom did not change and all the FRUs have been exchanged, call your service support person for assistance.

If the symptom has changed check for loose cards, cables, and obvious problems. If you do not find a problem return to “Step 1540A-1” on page 2-22 in this MAP and follow the instructions for the new symptom.

One of the FRUs remaining in the system is defective.

YES	Repeat	this	step,	adding	one SCSI device at a time,
	until	all the SCSI		devices	that were attached to the integrated SCSI
	adapter are		connected and		tested.
	Go to	“Step	1540A-10.”

Step 1540A-10

The	system	is working	correctly with this configuration. One of the FRUs (adapters)
that	you	removed is	probably defective.

1. Make sure the diagnostic CD-ROM disc is inserted into the CD-ROM drive.

2.Turn the power off.

3.Plug the diskette drive cable into the diskette drive connector on the system board.

4.Turn the power on.

5.After the keyboard indicator is displayed, press the F5 key on the

directly-attached keyboard or the number 5 key on an ASCII terminal keyboard.

6. Enter the appropriate password when prompted to do so.

Is the "Please define the System Console" screen displayed?

NO

In	the following	order,	exchange the	FRUs that have not been exchanged.
1. Diskette drive
2.	Diskette drive cable
3.	System board	(See	notes on page	2-1.)

4. Power supply

YES Go to “Step 1540A-11” on page 2-33.

2-327043 43P Series Service Guide