
Step
1.Turn the power off.
2.Reconnect the system console.
Notes: |
|
|
|
|
|
|
|
|
|
a. If an | ASCII | terminal has | been | defined | as | the | system console, attach | the | |
ASCII terminal cable to the S1 connector | on the rear of the system unit. | ||||||||
connect | the internal | serial | and | Ethernet | cables to the system board. |
| |||
b. If a display attached to a display | adapter has been defined as the | ||||||||
console, install the display adapter and | connect | the display to it. Plug | the | ||||||
keyboard into | the | keyboard | connector on | the | rear of the system unit. |
|
3.Turn the power on.
4.If the ASCII terminal or graphics display (including display adapter) are connected differently than before, the Console Selection screen will appear and
require that a new console be selected.
5.When the keyboard indicator is displayed, press the F1 key on the direct
attached | keyboard | or | the | number 1 | key | on | an | ASCII | terminal. This | triggers the | |
SMS. |
|
|
|
|
|
|
|
|
|
|
|
6. Enter | the | appropriate | password when | prompted | to | do | so. |
| |||
7. Wait | until | the SMS | screen is | displayed or | the | system appears to | stop. |
Chapter 2. Maintenance Analysis Procedures