Step
One of the FRUs remaining in the system unit is defective.
1. Turn the power off.
2. Exchange one of the FRUs in the following list.
Ÿ System board (See notes on
ŸPower supply.
3.Turn the power on.
Does | the operator | panel | do | one | of the | following: | ||
Ÿ | Stop | with | any | code | other | than |
| |
| – | FDC, | FF2, | FF3, | or | F4D | (Model | 140) |
| – | E1DC, | E1F2, | E1F3, | E1F7, | or E14D (Model 150) |
ŸAlternate between
– | FFD | and | any | other | code | (Model | 140) |
|
|
|
|
|
|
|
|
|
| ||||
– | E1FD | and | any | other | code | (Model | 150) |
|
|
|
|
|
|
|
|
|
| ||||
NO | Go | to | "Map | 0410: | Repair | Checkout"Diagnosticsin the | Information | for |
|
|
| ||||||||||
| Multiple | Bus | Systems. |
|
|
|
|
|
|
|
|
|
|
|
| ||||||
YES | Reinstall | the |
| original | FRU. |
|
|
|
|
|
|
|
|
| |||||||
| Repeat this step until the | defective FRU is | identified | or | all | the FRU | |||||||||||||||
| been exchanged. |
|
|
|
|
|
|
|
|
|
|
|
|
| |||||||
| If | the | symptom | did | not | change | and | all the FRUs have been | exchanged, | ||||||||||||
| call | your |
| service | support | person | for | assistance. |
|
|
|
| |||||||||
| If | the | symptom | has | changed, | check | for | loose cards, | cables, | and | obvious | ||||||||||
| problems. | If | you | do | not | find a problem, | return | to | “Step | on | |||||||||||
| page |
| in |
| this | MAP, | and follow | the | instructions | for | the | new | symptom. |
Chapter 2. Maintenance Analysis Procedures