IBM SA38-0512-03 manual System Management

Press Enter when you are finished; you must type the password again for verification.

If you make			a	mistake, Escpresskey theand start				again.
Note:	If	an	error		occurs	when you attempt to set			the privileged-access password,
	then	make		sure	the	password-enabling jumper has			been changed. (See the
	User's	Guide		for instructions on changing the password-enabling						jumper.)
After	you	have		entered		and	verified the	password,	the privileged-access password
icon	flashes		and changes to the locked position to						indicate that your system unit now
requires		the	password you				just entered before running system			programs.

Attention: Once the password-enabling jumper has been changed and the privileged-access password has been set, great care must be taken to preserve the privileged-access Ifpasswyourd.set the privileged-access

password and later misplace it, your system must be returned for service.

In order to prevent loss of system use, please record the privileged-access password immediately whenever it is changed.

Attention:		If	no	user-defined boot-list exists, and the privileged-access password
	has	been		enabled, you are asked for the privileged-access password at
	startup		every time		you boot up your system.
Moving	the	password-enabling			jumper back to the defaultnot dipositionable does
or erase		the		privileged-access password. Removing the jumper or moving the
jumper	back		to	the default position only prohibits changing or disabling this password
with	the	System		Management	Services.

7-167043 43P Series Service Guide