Step
1. Make sure the diagnostic
2. Turn the power off.
3. Plug the internal SCSI cable into both SCSI connectors on the system board.
4. Disconnect | the | signal and | power connectors from | all the SCSI | devices except | |
the |
| drive. |
|
|
| |
5. Make | sure | the | SCSI chain | is properly terminated; | see “SCSI | Bus Termination” on |
page |
|
|
|
| ||
6.Turn the power on.
7.After the keyboard indicator is displayed, press the F5 key on the
8. Enter the appropriate password when prompted to do so.
Is the "Please define the System Console" screen displayed?
NOOne of the FRUs remaining in the system unit is defective.
In the following order, exchange the FRUs that have not been exchanged:
1. SCSI cable
2. Last SCSI device connected
3.The graphics adapter, if the system console is defined as a graphical display.
4.Riser card
5. System board (See notes on page
6.Processor card
7.Power Supply
| Repeat this | step | until the defective FRU is | identified or | all | the FRUs have | ||||||||
| been | exchanged. |
|
|
|
|
|
|
|
|
|
| ||
| If | the | symptom | did | not | change and all the FRUs have | been | exchanged | ||||||
| call | your | service | support | person | for | assistance. |
|
|
| ||||
| If | the symptom has changed check for loose cards, cables, and obvious | ||||||||||||
| problems. If you do not | find a problem return to “Step | on | |||||||||||
| page | in | this | MAP | and | follow | the | instructions | for the | new | symptom. | |||
7043 43P | Series | Service | Guide |
|
|
|
|
|
|
|
| |||
