Administrator’s Manual
•Select T1 (RBS).
•Select “Coding”.
•Two options are presented “AMI” or “B8ZS”.
•Select the required option.
The default setting is AMI. A solid diamond indicates the option selected.
Programming the Line Build-Out on the T1
The Line Build out can be set at 0dB,
•From the programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
•Select “System Programming”.
•Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key ( ) until “ T1 (RBS) or PRI (ISDN)” is displayed.
•Select T1 (RBS).
•Select “Line
•Select the required option. The default is
Programming the Line Types on the T1
The Line Type can be set as E&M (default), DID, Loop Start or Ground Start.
•From the programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
•Select “System Programming”.
•Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key ( ) until “T1 (RBS) or PRI (ISDN)” is displayed.
•Select T1 (RBS).
•Select “Line Type”.
•Select the required option.
The default is that all lines are set as E&M.
Programming the Service Types
Once the line type is selected the Service Types relevant to the particular type of line is presented.
For E&M Line Type the following Service Types are available: - None - No Service Type is set.
ANI
DNIS *ANI* *DNIS* *ANI*DNIS*
•From the programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
•Select “System Programming”.
•Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key ( ) until “T1 (RBS) or PRI (ISDN)” is displayed.
•Select T1 (RBS)
•Select “Line Type”.
•Select “E&M” line type.
•Select one of the options listed above.
The default setting is “None”; A solid diamond indicates current selection.
For DID Line Types the following options are available: - None - No Service Type is set.
ANI
DNIS *ANI*
105