Inter-Tel 3000
Administrator’s Manual
*DNIS*
*ANI*DNIS*
•From the programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
•Select “System Programming”.
•Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key ( ) until “T1 (RBS) or PRI (ISDN)” is displayed.
•Select T1 (RBS).
•Select “Line Type”.
•Select “DID” line type.
•Select one of the options listed above. The default setting is “None”,
For Loop Start Line types the following options are available: - None - No Service Type is set.
Caller ID.
•From the programming extension, press the PROGRAM key.
• Press the Scroll Down key ( ) until “System Programming” is displayed.
•Select “System Programming”.
•Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key ( ) until “T1 (RBS) or PRI (ISDN)” is displayed.
•Select T1 (RBS).
•Select “Line Type”
•Select “Loop Start” line type.
•Select one of the options listed above. The default is that no service type is set.
If Ground Start is selected no additional menu is presented. There are no services available on Ground Start lines.
Programming the Start Types
When E&M Service Type is selected four Start Types are available.
Immediate.
Wink.
Delay Dial.
Dial Tone.
•Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key ( ) until “T1 (RBS) or PRI (ISDN)” is displayed.
•Select T1 (RBS).
•Select “E&M”.
•Select the service type.
•The list of Start Types is presented.
•Select the required Start Type. The default is Wink Start.
When DID Service Type is selected three Start Types are available.
Immediate.
Wink.
Dial Tone.
•Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key ( ) until “T1 (RBS) or PRI (ISDN)” is displayed.
•Select T1 (RBS).
•Select “DID”.
•Select service type.
•Select one of the options from the above list.
106
