Acronyms Used in this Manual | JVC Model 200 specification

Chapter 1---Introduction

Balldriver, 8mm

Ballpoint L-Wrench Set, 1.5-5mm

Delrin .100 Hex Alignment Tool

Gloves, ANSI/ASTM 10,000 volt rated, Safety

Goggles, Safety, x3(covers on) and x5(covers off)

Hex Ballpoint Driver, 3mm

Hex Ballpoint Driver, 5mm

Nutdriver, 10mm

Nutdriver, 11mm (or 7/16”)

Nutdriver, 5mm

Nutdriver, 7mm

Nutdriver, 8mm

Screwdriver, Phillips, #1

Screwdriver, Phillips, #2

Screwdriver, Pozidrive, #1

Screwdriver, Pozidrive, #2

Screwdriver, Slot ¼”

Screwdriver, Slot, ½”

Screwdriver, Slot, 3/16”

Socket, ¼” drive, 7mm-deep

1.4Acronyms Used in this Manual

ALPS	Arc Lamp Power Supply
CDB	Convergence/Deflection Board
CH	Channel
CPU	Central Processing Unit
CRT	Cathode Ray Tube
EMI	Electromagnetic Interference
FLASH	Erasable Programmable Read-Only Memory
EPROM
FPGA	Field Programmable Gate Array
F to V	Frequency to Voltage
G2	CRT Grid 2
HVDB	Horizontal/Vertical Deflection Board
HDTV	High Definition Television
Hz	Hertz
HSYNC	Horizontal Sync
HVDB	Horizontal/Vertical Deflection Board
HVPS	High Voltage Power Supply
IIC	Inter-Integrated Circuit
ILA®	Image Light Amplifier
I/O	Input/Output
I/R	Infrared
kHz	Kilohertz
LED	Light Emitting Diode
LVPS	Low Voltage Power Supply
NTSC	National Television Standards Committee
PAL	Phase Alternating Line
PCB	Printed Circuit Board
PLL	Phase Lock Loop

1-2	Model 200 Service Manual