
|
|
|
| Chapter |
|
|
|
|
|
| |
| I | 8 | TP_KEY | Data for adjustment of top/bottom keystone | |
|
|
|
|
| |
| I | 8 | TP_KEY_BAL | Data for adjustment of top/bottom keystone | |
|
|
|
| balance | |
| I | 1 | /RASTER_FIL | Control line for the raster fill option, low = raster | |
|
|
|
| fill is active | |
| I | 1 | /CONV_ENABLE | Convergence enable line low = enabled | |
|
|
|
| convergence | |
| O | 1 | ILA_LOCKED | Status line for the lock indication of the PLL of the | |
|
|
|
| ILA section with high = locked PLL | |
| O | 1 | /CD_OK | Convergence board status line. Low = | |
|
|
|
| operational C/D Board, High = Nonoperational | |
|
|
|
| C/D Board. | |
| O | 2 | CD_MODEL | Revision of C/D Board | |
|
|
|
|
|
|
|
|
|
|
|
|
| The Convergence/Deflection Board I/O | |
| This section describes the inputs to and outputs from the C/D | |
| Board. The I/O descriptions are arranged by the source and | |
| destination of the signal. The assembly communicated with is the | |
| primary heading of each group of signals. Those signals are | |
| subdivided into inputs and outputs. Input refers to an Input to the | |
| C/D Board, output refers to an output from the C/D Board. | |
Table | ||
| System Controller Board | |
|
| |
INPUTS | DESCRIPTION | |
|
| |
IIC_CLK | IIC clock line. Unidirectional clock line for control of synchronous | |
| data transfer over the IIC bus interface. | |
IIC_DATA | IIC data line. Bidirectional serial line for synchronous data transfer | |
| between the System Controller Board and the C/D Board. | |
X_RED_ | Red X convergence waveform. The amplitude for full scale | |
CONV | correction is about 1 VPP. | |
X_GRN_ | Green X convergence waveform. The amplitude for full scale | |
CONV | correction is about 1 VPP. | |
X_BLU_ | Blue X convergence waveform. The amplitude for full scale | |
CONV | correction is about 1 VPP. | |
Y_RED_ | Red Y convergence waveform. The amplitude for full scale correction | |
CONV | is about 1 VPP. | |
Y_GRN_ | Green Y convergence waveform. The amplitude for full scale | |
CONV | correction is about 1 VPP. | |
Y_BLU_ | Blue Y convergence waveform. The amplitude for full scale | |
CONV | correction is about 1 VPP. | |
CORR_ | Square wave HCT level synchronization signal for horizontal axis | |
SYNC | ||
| ||
OUTPUTS | DESCRIPTION | |
|
| |
/IIC_SINT | IIC interrupt line. Convergence board does not initiate any IIC | |
| interrupt. |
Model 200 Service Manual |