
Chapter
error. If it occurs, copy the 3 lines that appear on the screen, note what occured just prior to this failure, and call
5.3. Troubleshooting Guide
Table
Table 5-3. Troubleshooting Guide.
PROBLEM | CHECK | POSSIBLE SOLUTION | SECTION |
|
|
|
|
No Power | Main Circuit Breaker on | Reset Circuit Breaker. |
|
| Projector rear panel. |
|
|
| Main Circuit Breaker fails | Verify input power is | 4.5 and 4.6 |
| when reset. | correct. Replace |
|
|
| defective Low Voltage |
|
|
| Power Supply or Arc |
|
|
| Lamp Power Supply. |
|
| Power Interlock Switch | Test switch operation. If |
|
|
| defective, replace switch. |
|
| Projector cover not | Reposition projector | 4.2 |
| enabling interlock | cover. |
|
| switch? |
|
|
|
|
|
|
No Picture | Correct channel input & | Select correct channel | User’s Guide 4.6 |
| VIC selected? | and VIC. |
|
| Arc Lamp turned off. | Restart projector. | User’s Guide 4.3. |
| System power turned off. | Restart projector. | User’s Guide 4.3. |
| Signal source | Verify signal source is | User’s Guide 3.5. |
|
| turned on and properly |
|
|
| connected. |
|
| HIDE command | Unhide image with the |
|
| invoked? | HIDE key on the remote. |
|
| One color is missing. | Turn on the missing color |
|
|
| with the HIDE key. |
|
| No image or raster on | Replace defective CRT or | 4.15, 4.13 |
| one CRT. | Video Amplifier Board. |
|
|
|
|
|
Arc Lamp | Arc Lamp will not light. | Replace worn out Arc | 4.4 |
| Clicking noise is heard | Lamp. |
|
| when projector is turned |
|
|
| on. |
|
|
| Clicking noise not | LVPS, ALPS, or Ignitor | 4.6, 4.5, 4.4 |
| audible when projector is | faulty. Replace LVPS, |
|
| turned on. | ALPS, or Ignitor. |
|
| Arc Lamp ignites but will | Replace defective Ignitor. | 4.4 |
| not stay lit. |
|
|
Model 200 Service Manual |