Chapter 4---Maintenance (Removal/Replacement)
9.Remove the Rollbar assembly (2 pozidrive bolts/nuts on left side and two nuts on right side). Disconnect and label the 2 connectors on the hinge assembly for the shutter motors (1 in front and 1 in rear). Remove and label the jumper that connects the front interlock switch to the rear interlock switch.
10.Remove the Rollbar Bracket that was holding up the left side of the Rollbar assembly.
11.Remove the 3 ILA® asssemblies (Section 4.15).
12.Remove the remaining three hex bolts from the rear of the Prism assembly. These screws are located in the cavities where the ILA® assemblies were removed (see Figure 4- 15).
13.The Prism is now free to be removed.
CAUTION!!! The Prism assembly is heavy (about 70 lbs). Use two people to lift it out of the projector.
14. Replace the Prism assembly in the reverse order.
Model 200 Service Manual |
