
Safety Information
Installation Safeguards
WARNING!!! Procedures in this service manual require removing the projector’s covers to access internal component to remove, replace, service and adjust the projector. Only Hughes- JVC Certified Technicians are qualified to perform these procedures. Before removing or replacing any internal components or subassemblies, verify that the circuit breaker on the back panel is in the Off position and remove the power plug. Any adjustments performed that require covers off and power on should be performed with extreme care. Be especially aware of all hazardous areas indicated by warning and caution labels.
CAUTION!!! Do not use a forklift to lift the projector without using a safe shipping pallet. Lifting the projector without supporting the weight at the foot locations can cause severe damage to the projector.
If there is any visible damage to the power cable, disconnect power to the projector until the damaged cable is replaced. Install the projector on a smooth,
If mounting the projector, use hardware that can handle a minimum of three (3) times the projector weight.
Heat Safeguards
Fans and Ventilation: The projector has multiple fans to cool the system. Do not block the intake or outflow of any fans. Heat is emitted within the system and must be properly dissipated to keep the system running correctly. Blocking air intake or exhaust ports can lead to projector overheating. Do not enclose the unit in a restricted space (refer to the physical access and thermal clearance illustration guidelines).
|
|
|
vi | Model 200 Service Manual |