Safety Information
Electrical Safeguards
High voltage access. Front
and rear covers contain safety interlocks. Defeat restricted to
WARNING!!! High Voltage points up to 40,000 volts are exposed inside the covers. Allow at least one minute for the high voltage to bleed off, even after power is turned off.
Due to high voltage danger, DO NOT TOUCH
•CRT cables. These cables can cause severe shock from a tiny, invisible crack or hole and should never be touched while projector power is on.
•
•
•
•
CRT anodes.
Main power ± supply posts. Arc Lamp main power ± posts.
CRT yoke assemblies and other proximity electrical assemblies, components and wiring. If performing the ILA® Back Focus, CRT Mechanical Focus, CRT rotation, or ILA® Overlap adjustment, as outlined in Chapter 3, always use an ANSI/ASTM 10,000 volt rated glove. Periodically check the condition of the gloves for cracks.
Power Supply
The projector operates from a 100V - 240V, 20 Amp, single- phase, 50/60 Hz AC power source. Ensure local power source matches these requirements before operating!
For continued safe and reliable operation, only use cables supplied by the manufacturer for power and signal connections.
Fluid Safeguards
Certain components of the projector contain fluid. If any fluid from the projector contacts the skin, wash off with soap and water. If any fluid from the projector splashes into the eyes, rinse with cool running water.
viii | Model 200 Service Manual |
