Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
ADVANCED PROCESS PANEL
REMOVAL AND REPLACEMENT (continued)
FIGURE F.26. – CASE FRONT SCREW REMOVAL
AMPS | VOLTS | |
CONTROL |
| WELD TERMINALS |
REMOTE |
| REMOTE |
LOCAL | OUTPUT | ON |
|
| |
SELECT | SELECT |
MEMORY BUTTON | SELECT ATTRIBUTE |
SELECT KNOB | ADJUST ATTRIBUTE |
Phillips Head |
| Flathead Screws |
_ |
| |
Screws | + | |
|
|
5/16" Screws
Return to Section TOC
Return to Master TOC
5.Using a 5/16” nut driver remove the two screws from the bottom of the front of the machine. See Figure F.26.
6.Using a flat head screwdriver remove the two screws and their washers from above and below the input power switch. See Figure F.26..
7.Using a phillips head screwdriver remove the four screws from around the two welder output terminals on the front of the machine. See Figure F.26.
8.The front of the machine may now gently be pulled forward to gain access to the mode board. Note: The front of the machine cannot be removed completely, only pulled forward a few inches.
