Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
| ||||
|
| TROUBLESHOOTING & REPAIR | ||
|
| SNUBBER BOARD REMOVAL AND REPLACEMENT (continued) | ||
| PROCEDURE |
|
| |
1. | Remove input power to the | 3. | Perform the Input Filter Capacitor Discharge | |
|
|
|
| Procedure detailed earlier in this section. |
2. | Using a 5/16” nut driver remove the case wrap- | 4. | Locate the snubber board.. See Figure F.32. | |
|
| around cover. | ||
FIGURE F.32. – SNUBBER BOARD LOCATION
Snubber 
Board
LEFT SIDE
TOC
5.Remove small lead #B1 from the board. See Figure F.33.
6.Remove the four bolts using a 7/16” socket. Two of these bolts have leads #30 and #10 connected to them. Note the position of all leads and associ- ated washers upon removal.
7.Carefully remove the snubber board.
8.Replace the snubber board.
9.Replace the bolts, leads, and washers previously removed. Torque bolt to
10.Replace the case wraparound cover.
Return to Section
Return to Section TOC
Return to Master
Return to Master TOC
FIGURE F.33. – SNUBBER BOARD LEADS (CLOSE UP)
Lead 30
Lead B1
Lead 20
