ACCESSORIES
Return to Master TOC
Return to Master TOC
CONNECTION OF THE
NOTE: AN
1.Remove input power to the
2.Connect the K1505 control cable from the
3.Connect the electrode cable to the output terminal of polarity required by the electrode. Connect the work lead to the other terminal.
4.Set the meter polarity switch on the front of the
5.Set “CONTROL SELECT” to “REMOTE”.
6.Set the “MODE” to the
7.Set the “WELD TERMINALS SELECT” to the “REMOTE” position.
8.Set the “ARC CONTROL” to the “0” position and then adjust to suit.
9.Set wire feed speed and voltage at the
10.See the
11.The control DIP switch inside the
Return to Section TOC
Return to Section TOC
Figure C.8 LN-10 V350-PRO
14 PIN
TO
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
AMPHENOL (24/42VAC)
AT REAR OF MACHINE
+ | - | K1505 |
|
| TO WORK |
