![](/images/new-backgrounds/1327881/32788171x1.webp)
ACCESSORIES
Return to Master TOC
Master TOC
CONNECTION OF THE LN-742 TO THE V350-PRO (SEE FIGURE C.7)
NOTE: AN
1.Remove input power to the
2.Connect the electrode cable from the
NOTE: Figure C.7 shows the electrode connected for positive polarity. To change polarity, shut the welder off and reverse the electrode and work cables at the output terminals.
NOTE: Welding cable must be sized for current and duty cycle of application.
3.Connect the K591 control cable to the 24/42VAC 14 pin amphenol on the back of the
4.Set the “VOLTMETER” switch to “+” or
5.Set the “MODE” to the
6.Set “CONTROL SELECT” to “LOCAL”.
7.Place the “WELD TERMINALS SELECT” in the “REMOTE” position.
8.Adjust wire feed speed at the
9.Set the “ARC” control at “0” initially and adjust to suit.
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to
Return to Master TOC
Return to Master TOC
Figure C.7 V350-PRO/LN-742 Connection Diagram
|
| TO |
14 PIN |
| CABLE PLUG |
AMPHENOL |
|
|
(24/42VAC) |
|
|
AT REAR OF |
|
|
MACHINE |
|
|
+ | - | K591 CONTROL CABLE |
|
| |
|
| ELECTRODE CABLE |
|
| TO WIRE FEED UNIT |
|
| TO WORK |