Return to Section
Return to Master
5.Using a 5/16” nut driver remove the two screws from the bottom front of the machine. See Figure F.30.
6.Using a flat head screwdriver remove the two screws and their washers from around the input power switch. See Figure F.30.
7.Using a phillips head screwdriver remove the four screws from around the two welder output termi- nals on the front of the machine. See Figure F.30.
8.The front of the machine may now gently be pulled forward to gain access to the remote Board. Note: The front of the machine cannot be removed completely, only pulled forward a few inches.
9.The remote board is now accessible to replace.
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
FIGURE F.30. – FRONT SCREW REMOVAL
AMPS | VOLTS | |
CONTROL |
| WELD TERMINALS |
REMOTE |
| REMOTE |
LOCAL | OUTPUT | ON |
|
| |
SELECT | SELECT |
MEMORY BUTTON | SELECT ATTRIBUTE |
SELECT KNOB | ADJUST ATTRIBUTE |
Phillips Head |
| Flathead Screws |
_ |
| |
Screws | + | |
|
|
5/16" Screws
