Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
ADVANCED PROCESS PANEL
REMOVAL AND REPLACEMENT (continued)
FIGURE F.28. – SCREW IN CAP
Small Flathead
Screwdriver
Return to Section TOC
Section TOC
Return to Master TOC
Master TOC
18.Replace the Advanced Process board.
19.Replace the two phillips head screws at the bottom of the advanced process board.
20.Perform the Remote Board Replacement
Procedure.
21.Replace the 9/16” nuts and their washers behind the “Adjust” and “Select” knobs.
22.Using a small screwdriver replace the two knobs previously removed.
23.Replace the three 5/16” screws previously removed from the front of the machine located around the Advanced Process board.
25.Replace the four phillips head screws removed from the front of the machine located around the two welder output terminals.
26.Replace the two flat head screws and their washers from around the input power switch.
27.Using a 5/16” nut driver replace the two screws previously removed from the bottom front of the machine
28.Replace the case wraparound cover.
Return to
Return to
24. Reconnect plug #J33 previously removed.
