Memory maps
http://www.motorola.com/computer/literature 1-5
1
Note The first 1MB of ROM/FLASH Bank A (soldered Flash up
to 8MB) appears in this range after a reset if the rom_b_rv
control bit in the SMC’s ROM B Base/Size regi ster is
cleared. If the rom_b_rv control bit is set, this address range
maps to ROM/FLASH Bank B (socketed 1MB Flash).
For an example of the CHRP memory map refer to the following table. For
detailed processor memory maps, including suggested CHRP- and PREP-
compatible memory maps, refer to the Hawk re lated portion of this
manual.
Processor Memory Map
The following table describes a suggested CHRP Memory Map from the
point of view of the processor. This memory map is an alternative to the
PREP memory map. Note: in all recommended CHRP maps, the beginning
of PCI Memory Space is determined by the end of DRAM rounded up to
the nearest 256MB-boundry as required by CHRP. For example, if
memory was 1G on the baseboard and 192MB on a mezzanine, the
beginning of PCI memory would be rounded up to address 0x50000000
(1G + 256M).
FEF9 0000 FEFE FFFF 384KB Not Mapped
FEFF 0000 FEFF FFFF 64KB PCI Host Bridge (PHB) Registers
FF00 0000 FFEF FFFF 15MB Not Mapped
FFF0 0000 FFFF FFFF 1MB ROM/FLASH Bank A or Bank B (See
Note)
Table 1-2. Default Processor Memory Map (Continued)
Processor Address Size Definition
Start En d