NCR S26 manual Sample Standard Configuration

Sample Standard Configuration

To configure the SCSI adapters and drivers, if connected to an Adaptec SCSI adapter, follow these steps:

1. Press Ctrl + A when the following displays:

Adaptec AIC-7880 Ultra/Ultra Wide BIOS v1.22S2 <<Press hot key for SCSI Select (TM) Utility>>

(Refer to the Adaptec SCSI documentation for additional information about these settings).

2.Select SCSI Disk Utilities. Observe that the 2 GB disk drive and the CD- ROM drive are displayed with the correct information. If a low-level format on the 2 GB disk drive is needed, perform it now. It is usually not needed.

3.Select Configure/View Host Adapter Settings and set the parameters as follows:

SCSI Bus Interface Definitions
Host Adapter SCSI ID	[7]
SCSI Parity Checking	[Enabled]
Host Adapter SCSI Term	[Low OFF/High ON]
Boot Device Options:
Boot Target ID	[0]
Boot LUN Number	[0]

4. Select SCSI Device Configuration and set the parameters as follows:

SCSI Device ID (tab to desired device)
Initiate Sync Negotiation	[yes]
Maximum Sync Transfer Rate*	[40]
Enable Disconnection	[yes]
Initiate Wide Negotiation	[yes]
Send Start Unit Command	[yes]

*Note: See note in step 6.

NCR S26 Hot Plug Server User Guide C-9